Urgent question for those with Turner cam gears NOT installed

[Anders]

I'm creating some new fasteners for TMS cam gears that will enable us to adjust the gears without removing them from the cams. My gears are unfortunately installed, so I need someone to make a very precise measurement of the hole circled in yellow (not the deep threaded portion, just the outer 2 mm):



Thanks!!

[Ted B]

6.34mm

[Anders]

Thank you, Ted!!

I'm machining some shoulder bolts with hex heads that will be adjustable without pulling the gears. The shoulder will clamp against Nordlock serrated washers and I'll run them without the "lock bolt". This way the cam adjustment won't be lost if you pull the cams...

[Ted B]

Sounds good, keep me informed.

[Anders]

I asked you for another dimension in the other thread, Ted. What is the (radial) width of the "plateau", roughly covered by the yellow circle in the picture.

TIA,

[Ted B]

13.0mm

[Anders]

Thanks again!