mlytle
Registered
Last Activity: Yesterday, 03:30 PM
Joined: 04-23-2010
Location: M3
-
LOL...it is at a Volvo dealer....did some trade it in on an SUV? -
asking is one thing. someone actually paying that much is a whole 'nuther thing.....until that happens, the short supply and high demand cycle is not proven....Leave a comment:
-
I am gonna guess that was part in the problem. The Billy DAMPER was too long for spring allowing inside rear wheel to move uncontrolled.Leave a comment:
-
was the extended length of the koni the same as the billy?
ps - it is "damping" not "dampening"....unless you mean you were getting them wet driving through puddles.....Leave a comment:
-
and my ex-85 320 m-technic. fully adulterated with M3 interior and M50 swap....fairly rare Karminrot color.
...Leave a comment:
-
I will take them. Pm comingLeave a comment:
-
measured inside depth = 58.72mm. stock original rotor.Leave a comment:
-
probably cheaper to just leave California.......Leave a comment:
-
i have some junk stock rear rotors rusting outside my shop. will try to measure tomorrow if you still don't have a reply. inner hub bearing surface to edge of ebrake mating surface.Leave a comment:
No activity results to display
Leave a comment: