If its Emtron it will be Nick. He is the best of the best. He tuned mine with slide throttles and it runs like it was OEM tuned!!
T...
HANDBLT
2.7L Beast
Last Activity: 04-14-2021, 02:23 PM
Joined: 12-20-2002
Location: '90 DS AE34504
-
are you having Nick tune it?
T...Leave a comment:
-
I would think a few inches would be enough? cut off the excess and slot one side and clamp it down.
T...Leave a comment:
-
Thanks! I'll be at VIR full April 23/24/25 for the first shakedown and final tweaks. Should be a good weekend since I worked out most of all the other issues during three different track days late last...Leave a comment:
-
Took the car out for its maiden voyage on the street. Drove for about 2 hrs in stop and go traffic, some open back roads, and some blasts on the interstate.
Drove like it was an OEM level...Leave a comment:
-
I have a complete setup from a friend that sold his car, and if I can get into the ECU ill send you a base map. He used the ford edis and a 36-1 crank trigger.
T...Leave a comment:
-
This is on the superflow with a road speed of 140ish @ 8500. The Dyno is applying aero drag as well to simulate read world 'rolling road' conditions.
T...Leave a comment:
-
From John's site s14power.com:
"cam lift is 12.039 and 10.095 mm. Lift at TDC is ~6.2 and ~4.2 mm, just for reference, but you do NOT time the cams by TDC values. You time them via...Leave a comment:
-
they were timed for the 'rallye' timing and not the circuit 'timing'. They were kept and I didn't go to to the 324/304 due to wanting more midrange and area under the curve. This is already so much in...Leave a comment:
-
8500 for the tuning, limited to 8000 for longevity.
T...Leave a comment:
-
The superflow is not an inertia Dyno. It is a load based dyno. It reads lower than a Mustang does. It did 240whp the first time I had it there, then that same setup did 285whp on a Dynojet a couple months...Leave a comment:
-
For sure! we should have a good crowd again. That was so fun last year! lets get 12-15 E30 M3's to the track again this spring!!
T...Leave a comment:
-
The next place this will show up, is on a video, from the balcony of the garage suites, at VIR. You'll hear it coming, from the top of the roller coaster, all the way to the braking zone for turn one...Leave a comment:
-
Nick Pavloski with Cohesion. The best of the best. He has about 15 cars he supports in AER among other things. Never have I ever talked to someone that knew this part of the work like he does. A true...Leave a comment:
-
I'll get the plots tonight. It has a 4.10 diff in it with the GrpA trans, so around 140mph @ 8000rpm with 225/40/17 Hoosier slicks. I need to have a 3.91 or 3.73 diff build this year for it. I already...Leave a comment:
-
picked up around 20whp on a superflo dyno. She's over 300whp (dynojet numbers) now on 93 octane pump gas.
...Leave a comment:
-
yes they are build from scratch with all the sensors and lengths that you send him.
T...Leave a comment:
-
The vacuum sensors and other sensors mounted to the firewall are the MAP sensor and any other sensor you don't want susceptible to long term engine vibrations. I have all my sensors remote mounted like...Leave a comment:
No activity results to display
Leave a comment: