182 results in 0.2437 seconds.
-
If the engine isn't cranking over when you try to start it, it's a problem in the starter or the electrical circuit associated with the starter. The ignition coil has nothing at all to do with it - if... -
Mine would stay mostly at halfway, creeping a needle or two past from time to time. I pulled the gauge cluster, cleaned and tightened the grounds, and then put it back in. Now, the normal position is...Leave a comment:
-
A number of years ago, I tried the HPS pads on my E36M3. Unfortunately, I didn't like them very much. My use was street and a lot of autocrossing, and the pads just didn't have enough initial bite for...Leave a comment:
-
Thanks for the response. I went down to my local BMW wrecking yard, but unfortunately all they had were new ones. The counter guy said that the ones on the early e30s with the button on the side seem...Leave a comment:
-
WTB Left front seat belt receptacle
I'm looking for a left front seat belt receptacle in good condition - maybe a pair, if they're both in really good shape. Anyone have these for sale?
Thanks in advance... -
Did you bench bleed the master cylinder before installing? I've run into the same sort of problem before, where the pedal wasn't as hard as it should be after changing the master cylinder, even after...Leave a comment:
-
Hmmmm.....I would have thought that if the ECU wasn't getting info from the reference sensor on the flywheel, both spark and fuel injection would be disabled... Anyway, could the two sensors on the bell...Leave a comment:
-
On the turbocharged V6 engines that I work on, I've found that too little timing at idle causes the idle to be fairly weak. Sometimes to the point where smoothly taking off from a stop is hard, or the...Leave a comment:
-
Leave a comment:
-
We did a whole fuel system in Goodridge 910 hose and fittings, and IMHO, I think it looked way cooler than stainless steel braided hose...but I have to admit, we did a dry sump setup using a stainless...Leave a comment:
-
If you don't need the abrasion resistance of a steel-braided hose, I'd suggest using one of the Kevlar/Aramid/polyester/nylon braided hoses. Much easier to work with - cutting is easy, no stainless steel...Last edited by Whee30M3; 06-24-2013, 01:47 PM.Leave a comment:
-
I think that it's kind of weird that in 4+ years of selling that intake on R3vlimited, no one has posted a dyno chart, intake air temp data logs, or anything else that suggests that this intake makes...Leave a comment:
-
Maybe a place that repairs carbs has a suitable screw? Or maybe a manufacturer of throttle bodies, like TWM Induction?Last edited by Whee30M3; 06-16-2013, 05:48 AM.Leave a comment:
-
None of us, including the original poster, have any idea what went wrong with the engine. All we know is that the engine "blew" - what exactly does that mean? Does it mean that it threw a rod, spun...Leave a comment:
-
You can also get them from McMaster-Carr:
http://www.mcmaster.com/#pipe-routing-clamps
(scroll down to the "Double-line snap-in plastic clamps")Leave a comment:
Leave a comment: