287 results in 0.1773 seconds.
-
And then there's the shocking quality of some stuff they have reproduced !!... -
Out of interest what percentage of Ethanol are you guys having to deal with? Over in the Uk we've got e10 and that seems to absorb more moisture, has a short shelf life, discolours brass and pits ali...Leave a comment:
-
May not apply here, but...........
On a RHD converted car, the steel rack (early 325?) started weeping (no rubbing issues at all on 16" rims 225 tyres) so I changed it for a later Aluminium...Leave a comment:
-
Is this the time to go 2.7?Leave a comment:
-
Hi there,
Thanks for your question..........
The car is located in the South East of England UK.Leave a comment:
-
For Sale RHD converted car
For Sale RHD 1987 Converted Car
RHD converted 1987 M3.
Positives are lots of mechanical work done.
Rear wheel bearings and drive shafts, propshaft uj's and centre bearing, Miltek... -
Leave a comment:
-
Think this head is past the epoxy repair stage as the corrosion has gone into the metal fire ring now judging by the photos. Although if it was just around the water passages it possibly would tidy it...Leave a comment:
-
Although the corrosion looks nasty its all repairable just needs cutting into and welding up and the head resurfaced (fly cut) Used to see the same on the 6 cyl e30`s from lack of inhibitor or wrong ...Leave a comment:
-
That's interesting, a Twin Mass Flywheel? You normally find that sort of plate on an automatic transmission where the flexiplate bolts onto the crank....Leave a comment:
-
Looks like a factory install.
Any machining needed to the cover? Are they correct length wise?...Leave a comment:
-
That's what I did on mine, launch both pumps and just use the 318is cage and pump. Mines only a road car not for the track...................Leave a comment:
-
Apologies if you've tried it or people have suggested this.......... What about the wiring in the engine compartment? All these wires have had many years of heat, water, cold thrown at them. Could it...Leave a comment:
-
Would agree with the above. Keep looking at it, you may end up liking it. Just wrap or spray the shell for a good combo
Leave a comment:
-
The fact that you knew about the stamped measurement was enough for me
Just going to mark you down slightly on the accuracies Only Kidding..............
Leave a comment:
Leave a comment: