1000 results in 0.7004 seconds.
-
IndyM3 Feb 11
I bought a driveshaft listed on his feb ad. The Item arrived promptly and in good condition. I recommend Jon as a trustworthy seller, and easy to deal with. thanks. m... -
Try a larger front anti roll bar. It takes a lot of spring rate to combat the body roll that is inherent in the front strut suspension. Ideally you need both spring and bar rate increases. m... -
21511223281. Yes your number is the correct one.
m...Leave a comment:
-
I would leave it alone. It could be a *3 dimensional* leak where 3 surfaces meet. One has to take care to make the surfaces match and typically the builder adds a smear of sealant to plug any crevice or ho...Leave a comment:
-
The bottom line is that there was no replacement for the E30M3 in the US. The marketing department undermined the Motorsport dept and provided us with the E36 330iS and then the 332iS in 1996my.
...
Leave a comment:
-
Sorry, but that is not entirely correct. Symptoms one can expect. 1, snatchy clutch take up. 2, noise that varies from whirring to squealing to growling, when the clutch pedal is depressed. 3, A grainy vibratio...Last edited by Mmark; 03-27-2013, 01:06 AM.Leave a comment:
-
The E36 battled the Audi A4(in FD and 4WD), and Peugeot in the German series and the Australian series. iirc, this was a 2.0 litre world wide reg. The racing was fierce and quite even. I recall Geoff...Last edited by Mmark; 03-27-2013, 12:56 AM.Leave a comment:
-
2151122381 metal is dimensionally the same as stock.
mLeave a comment:
-
What class? You won't get reasonable answers if the question is vague. Sanctioned Autox clubs usually have rulebooks. You'll need to read the rule book before you modify the car. m...Leave a comment:
-
I don't have damper data but as an anecdote: The 325iS spring rates are F 118 lbs/in R 265 lbs/in. The M3 spring rates are F114 lbs/in R 314Lbs/in. According to June 87 Motor magazine. m...Leave a comment:
-
The engine mounts are a maintenance item. The passenger side mount is located close to the primaries on the hot side of the engine bay....It won't survive for more than 2 years if the car is used frequ...Leave a comment:
-
When the throttle is snapped open by direct manipulation of the linkage at the TBs, the action is too quick for the intake air column. It takes time for the air to accelerate and move into the vacuum...Leave a comment:
-
That thing needs the tappet clearances adjusted back to spec or new lifter buckets. I'd also remove the plenum and check the operation of the throttle plates. I take it that it still has a factory w...Leave a comment:
-
Oops.
How much damage did that do?
Couldn't have been too bad if you were about to complete the rest of the runs.
mLeave a comment:
-
The US vendors all list the same part# for the rear drive E30 chassis. I use an E30 325iS as a winter beater. it has E30 M3 springs and Bilstein sports. The A/C has been removed. The ride is slightly harsh...Leave a comment:
Leave a comment: