Thank you.
Will order the new one and give it a try....
122 results in 0.1002 seconds.
-
illiad,
Thanks for the link. That looks like the right light, but the site says it does not fit my 1990 M3, and the part numbers listed don't match the numbers I have for my car.
Can you...Leave a comment:
-
PM sentLeave a comment:
-
Parts supplier says the new part number does not contain the switch.
So, I am changing this to a WTB post for an original style cabin light assembly.
Thanks.Leave a comment:
-
WTB Original style cabin light with a switch
I am looking for a good working example of part number 63311372586.
It is the interior cabin light assembly with the switch so it can be controlled separately.
Thanks. -
Correct interior light part number.
My passenger side interior light housing broke at the interior portion of the switch. In searching for a new part, the original part number seems to have been superceded by two other numbers that cross... -
When I converted, I did not replace pipes, but the hood shock prevents permanent placement of the r134 valve at that location. I just left the r12 valve in place and screw on the r134 valve as needed....Leave a comment:
-
Where is your new high pressure valve located?...Leave a comment:
-
Best 90's cars with looming NLA parts
I like cars from the 1990's.
I am wondering what is the best car for me to own and keep in light of fear of nla parts.
I previously owned a 1997 Porsche Carrera. Since sold.
Current... -
Thanks everyone.
Couldn't find the BMW technical article though.Leave a comment:
-
Well at 2000rpm I was getting at most 34 psi low side, 225 psi high side with center vent at 64 F*. This at 90* ambient.
To my thinking, normal low and low high side equals bad compressor. ...Leave a comment:
-
R134a system pressures
My system has been converted to r134 for many years. Now it is not blowing as cold as it used to. I have the manual and the temp/pressure graph for r12, but wondered if the pressures were different for... -
Everyone has had this issue.
Search away and you will find a lot of discussions.
You will hear a lot about replacing all the shifter linkage bushings and possibly a weighted linkage rod...Leave a comment:
-
So why would the half shafts not slide into the hubs?Leave a comment:
-
I hadn't noticed it was no longer available. Markseven wrote, " have the HTML of xworks' build thread on r3v. PM me and I will share it". I will PM you for a copy if you please. Bill Z...Leave a comment:
Leave a comment: